Genuine Hyundai Sonata Water Pump

Hyundai Sonata Water Pump Parts Questions & Answers

• Pump Assembly-Coolant
  25100-25002
  Q: How to replace a water pump in a Hyundai Sonata?

  A: Buy non-toxic coolant from auto parts stores and dispose used coolant properly. Disconnect the battery cable and drain the cooling system. For 2005 and earlier models, remove timing belt covers, timing belt, water pump pulley and fasteners. For 2006 and later models, remove drivebelt, exhaust manifold, water pump pulley and fasteners. On four-cylinder models, remove water inlet pipe nut/bolt. Clean old gasket material or sealant from water pump and block, then clean with lacquer thinner. Install new gasket and water pump. Tighten bolts and nuts. Refill cooling system, run engine and check for leaks.
• Pump Assembly-Coolant
  25100-2G400
  Q: What are the signs and symptoms of water pump failure in an engine?

  A: A failure in the water pump can cause serious engine damage due to overheating. Water pumps are equipped with weep or vent holes. If a failure occurs in the pump seal, coolant will leak from this hole. The water pumps on 2005 and earlier models are located behind the timing belt covers. If you suspect water pump leakage, remove the cover. In most cases, it will be necessary to use a flashlight to find the hole in the water pump by looking through the space behind the pulley, just below the water pump shaft. A slight gray discoloration around the weep hole is normal, while dark brown stains indicate a problem. If the water pump shaft bearings fail, there may be a howling sound at the front of the engine while it is running. Bearing wear can be felt if the water pump pulley can be rocked up and down. Do not mistake drivebelt slippage, which causes a squealing sound, for water pump failure. This can occur on engines with adjustable drivebelts. Spray automotive drivebelt dressing on the belts to eliminate the belt as a possible cause of the noise.