Hyundai 37110-0W000 Battery Assembly

Detach the negative battery cable and then disconnect the positive one. Check to see if the battery is fully charged. Take a digital voltmeter and perform an open voltage circuit test. To get accurate voltage measurements, we must first remove surface charge from the battery. Turn on high beams for ten seconds, then off, and let sit for two minutes. With engine off and all accessories turned off as well, place negative probe of voltmeter on negative terminal of battery and positive probe on positive terminal of battery. The voltage output for this kind of a battery should be 12.6 to 12.9 volts. If it is lower than that level, recharge it before moving ahead to the next test because you will need it during this process again. Carry out a battery load test A proper check of the condition of a battery can only be made using a load tester This measure determines whether or not the battery has the ability to start up an engine or run other accessories when they are demanded in large amounts Attach a load tester onto terminals at some places in order to perform load testing as mentioned by manufacturer's instructions Keep adding more weight to what your batteries are capable of putting up with This is why I say that; observe that your batteries don't drop below 9.6 volts under no circumstance should they go beneath 9.6 volts throughout these fifteen seconds Disconnect the negative battery cable and then disconnect the positive one Remove hold-down clamp Lift out the black box Be careful-it's heavy Take out tray while removing black box Ensure tray is washed thoroughly in clean water in case there is any dust Presently replace pallet assuming it is broken or has been damaged If you're going to replace your batteries with new ones make sure that you replace them with similar ones i.e., same size, same cranking amps etc. Reverse installation.

To ensure that your vehicle's battery starts quickly and reliably, one must have a routine PM plan in place. Before you do any battery maintenance, ensure that you have the right safety equipment. In performing battery maintenance there are some precautions to take- this would involve switching off the engine as well as all other accessories and disconnecting the negative cable of the battery. Consequently, avoid causes for sparking such as smoking close by or matches when near it and charge it in a well ventilated area since the battery emits highly flammable and explosive hydrogen gas. It is important to remember that electrolyte used in batteries contains corrosive sulphuric acid which can cause serious burns on contact with skin, eyes or clothing or if swallowed. Take necessary safety measures such as wearing protective glasses gloves and old clothes especially when cleaning cable clamps. Inspect the outside of the battery looking for corrosion, loose terminal connections, cracks or damaged rubber boots. In case there is any corrosion present remove the battery; clean the terminals: cable clamps and top of the battery using a baking soda solution and also use a terminal cleaner if necessary. Make sure that your battery tray is in good condition and clamp down bolt tightened accurately. If removed check if any part remains on tray before anything else goes wrong. Cover corroded metal parts with zinc-based primer then apply paint on them .For batteries that are discharged completely or those used at low rates slow-rate charging is recommended mostly in winter periods .Use one or two ampere (A) charger for better results because these chargers are safe on batteries .Using chargers rated above 1/10th of the batteries amp/hour rating should be avoided Remove cell caps where available cover holes with a cloth ,disconnect negative cables attach charger clamps to satheame posts connecting positive to positive &negative to negative also 12 volts for applicable charges.For high amperage chargers monitor overheating of battery's. Following usual checks, a trickle charge can be used overnight. If there are removable cell caps on the battery, specific gravity can be measured with a hydrometer for the last few hours of charging ,which is considered charged when the readings of specific gravity stabilize and electrolyte gasses start to emit. Check if your batteries have built-in hydrometers that indicate their charge status through color or use a voltmeter; fully charged ones should read 12.6 volts or higher after bringing into equilibrium by removing surface charges.

Ensure the new battery is identical to the old one in terms of dimensions and ratings.

If the battery has removable cell caps, you can measure the specific gravity with a hydrometer every hour during the last few hours of the charging cycle.