Hyundai 97133-S8000 Air Filter Assembly

Removal steps: 1. Park on a level surface, set the parking brake, switch ignition off and remove the key/fob. 2. Put on gloves and eye protection before starting work. 3. As a precaution when working near electrical components, disconnect the negative battery cable and isolate the terminal. 4. Identify the cabin air filter housing location (typically behind the glovebox or under the instrument panel) by consulting the owner's manual or a repair guide. 5. Remove any trim, glovebox, or access panels required to reach the filter housing, keeping fasteners and clips organized. 6. Release the filter housing cover by unlatching or sliding the retainers as needed to gain access. 7. Carefully pull the old filter straight out to avoid spilling collected debris and note the airflow direction printed on the filter frame. 8. Inspect the housing for leaves, dust, or residue and remove debris with a vacuum or a soft brush and a lint-free cloth. 9. Dispose of the old filter according to local regulations. Installation steps: 1. Confirm the replacement filter is the correct type and check the airflow direction marking before installing. 2. Insert the new filter into the housing with the arrow oriented correctly and ensure it seats evenly without folding or pinching. 3. Reinstall the filter housing cover and secure all latches or retainers so the cover closes fully. 4. Reinstall any removed trim, glovebox, or panels and refasten hardware in the original locations. 5. Reconnect the negative battery cable and ensure the terminal is snug and free of corrosion. 6. Start the vehicle and cycle the HVAC through different fan speeds and modes to verify airflow and listen for unusual noises or vibration. 7. Confirm there are no air leaks at the housing and that doors/panels close without interference. 8. Repair tip: note the installation date and mileage on the filter or in your maintenance records to track replacement intervals.