Hyundai 94460-3K600 Fuel Pump Sender Assembly

You can Select Your Vehicle to check if 94460-3K600 fits your vehicle.

Yes, components such as the pressure regulator and pump may be serviceable with individual aftermarket parts that can be obtained from a local parts store.

Access the fuel pump module. On 1999 through 2005 models, it is located at the rear of the fuel tank under the vehicle (raise the vehicle and support it securely on jackstands). On later models, it's under a cover in the trunk floor. Remove the cover and disconnect the fuel pump electrical connector. Relieve the fuel system pressure and remove the fuel tank cap. Disconnect the cable from the negative battery terminal. Disconnect the fuel lines from the top of the fuel pump unit. Remove the retaining bolts from the fuel pump/fuel level sensor mounting flange. Carefully lift the fuel pump/fuel level sensor assembly from the fuel tank. Inspect the fuel pump inlet strainer for contamination. If it's dirty, try cleaning the strainer with some clean solvent and an old toothbrush. If the strainer is too dirty to be cleaned while it's installed, remove it from the fuel pump/fuel level sensor and try cleaning it again. If you still can't clean it adequately, replace it. Installation is the reverse of removal.