For 2005 and earlier models, begin by loosening the front wheel lug nuts, raising the vehicle securely on jackstands, and removing the front wheel. Open the
Hood and take out the upper edge fender bolts, then remove the headlight housing. Detach the inner fender well fasteners and the inner fender splash shield, followed by detaching the front
Bumper cover from the fender. Pull the front bumper cover loose and remove the two front fender bolts, then take out the fender-to-body bolts at the lower rear edge. Open the door to remove the upper rear fender bolt, and carefully lift off the fender, ideally with assistance to prevent damage to surrounding panels. For installation, reverse the removal steps and check the alignment of the fender with the hood and front edge of the door before final tightening of the fasteners. For 2006 and later models, start by loosening the front wheel lug nuts, raising the vehicle securely on jackstands, and removing the front wheel. Remove the headlight assembly and the front bumper cover, then take out the inner fender liner by removing its fasteners. Next, remove the two front fender bolts and release the plastic retainers to pull back the lower body side cladding strip. Remove the lower rear fender mounting bolts located under the cladding, followed by the fender upper mounting bolts from inside the engine compartment. Open the door to access and remove the upper rear mounting bolt, then lift off the fender. For installation, follow the reverse order of removal.