How to troubleshoot and replace a faulty blower motor in a Hyundai Accent?

If the blower motor doesn't work, disconnect its electrical connector and use a test light between the harness connector terminals. If the test light glows, the power and ground circuits are fine, and the motor should be replaced. If not, identify the power and ground terminals. Connect the test light to a good chassis ground and probe the power terminal. If the light doesn't illuminate, check the fuse, relay, and wiring. If it does, check the ground circuit's continuity. If the motor works at some speeds, disconnect the blower resistor's electrical connector and check for continuity. If any resistor is open, replace the assembly. If the resistors are fine, remove the control panel and check for continuity in the blower switch and wires. Check for continuity to chassis ground at the blower switch harness connector ground wire. To replace the blower motor resistor, disconnect the electrical connector and remove the screws. To replace the motor, remove the lower dash panel and glovebox, disconnect the connectors, detach the wiring harness, and remove the motor. Installation is the reverse of removal.

Genuine Hyundai Accent Blower Motor

A/C Heater Blower Motor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

6 Blower Motors found

View related parts
Hyundai Accent Motor Assembly-Blower
Part Number: 97111-1R000
$142.40 MSRP: $200.06
You Save: $57.66 (29%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Blower Motor
- Warranty: This genuine part is guaranteed by Hyundai's factory warranty.
Fits the following Vehicles:
- 2011-2017 Hyundai Accent | DOHC - GDI | Sedan - 4Door 5P, Sedan - 5Door 5P
View related parts
Hyundai Accent Fan & Motor Assembly
Part Number: 97113-1E000
$176.23 MSRP: $247.59
You Save: $71.36 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Blower Motor
- Warranty: This genuine part is guaranteed by Hyundai's factory warranty.
Fits the following Vehicles:
- 2005-2011 Hyundai Accent | High Grade, Middle Grade | DOHC - MPI | 3 Door Sedan, 4 Door Sedan, Sedan - 3Door 5P, Sedan - 4Door 5P
View related parts
Hyundai Accent Fan & Motor Assembly
Part Number: 97116-24951
$178.25 MSRP: $250.44
You Save: $72.19 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Blower Motor, Fan & Motor
- Warranty: This genuine part is guaranteed by Hyundai's factory warranty.
Fits the following Vehicles:
- 1999-2006 Hyundai Accent | Low Grade, Middle Grade | 3 Door Sedan, 4 Door Sedan
View related parts
Hyundai Accent A/C Blower Motor & Fan Assembly
Part Number: 97113-H9100
$134.18 MSRP: $188.52
You Save: $54.34 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Motor & Fan Assembly-A/C Blower; Blower Motor
- Warranty: This genuine part is guaranteed by Hyundai's factory warranty.
Fits the following Vehicles:
- 2018-2022 Hyundai Accent | DOHC - GDI, DOHC - MPI | Sedan - 4Door 5P
View related parts
Hyundai Accent Motor-Heater Blower
Part Number: 97111-22000
$239.51 MSRP: $336.50
You Save: $96.99 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Blower Motor
- Warranty: This genuine part is guaranteed by Hyundai's factory warranty.
Fits the following Vehicles:
- 1994-1999 Hyundai Accent | High Grade, Low Grade, Middle Grade | 3 Door, 4 Door
View related parts
Hyundai Accent Fan & Motor Assembly
Part Number: 97112-1C000
$179.10 MSRP: $251.63
You Save: $72.53 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Blower Motor
- Warranty: This genuine part is guaranteed by Hyundai's factory warranty.
Fits the following Vehicles:
- 1999-2006 Hyundai Accent | Low Grade, Middle Grade | 3 Door Sedan, 4 Door Sedan

Hyundai Accent Blower Motor

The Hyundai Accent Blower Motor spins an electric fan that pushes heated or cooled air into the cabin. This allows drivers to have quick command over the temperature and window defogging. Linked to easy-reach dashboard controls that are wired to an electronic control module, the Blower Motor varies airflow in clean steps. This enables Hyundai drivers to crank the heater on icy dawns or summon max A/C after parking under the harsh sun. Inside an Accent cabin, this responsive Blower Motor setup makes tweaks to the climate almost instinctive. All generations of the Accent rely on a single front-mounted Blower Motor because the compact interior leaves no need for rear-mounted units. This design choice keeps troubleshooting simple compared with larger Hyundai models, adding durability across the Hyundai lineup. When trouble strikes, symptoms jump out, from silent vents to a fan locked on one speed, often traced to snapped knobs, burned wiring, or a failed module rather than the motor itself. Swapping out damaged controls or the module usually revives the Blower Motor and returns full climate authority, keeping every Hyundai Accent comfortable through every season.

If you are looking for affordable high-quality OEM Hyundai Accent Blower Motor, then you have come to the prime place. Our website provides a large amount of genuine Hyundai Accent Blower Motor at unbeatable prices. All our parts come backed with the manufacturer's warranty.

Hyundai Accent Blower Motor Parts Questions & Experts Answers

Motor Assembly-Blower
97111-1R000
Q: How to troubleshoot and replace a faulty blower motor in a Hyundai Accent?
A:
If the blower motor doesn't work, disconnect its electrical connector and use a test light between the harness connector terminals. If the test light glows, the power and ground circuits are fine, and the motor should be replaced. If not, identify the power and ground terminals. Connect the test light to a good chassis ground and probe the power terminal. If the light doesn't illuminate, check the fuse, relay, and wiring. If it does, check the ground circuit's continuity. If the motor works at some speeds, disconnect the blower resistor's electrical connector and check for continuity. If any resistor is open, replace the assembly. If the resistors are fine, remove the control panel and check for continuity in the blower switch and wires. Check for continuity to chassis ground at the blower switch harness connector ground wire. To replace the blower motor resistor, disconnect the electrical connector and remove the screws. To replace the motor, remove the lower dash panel and glovebox, disconnect the connectors, detach the wiring harness, and remove the motor. Installation is the reverse of removal.