What information can you provide about Spool Valve and sensor locations on Hyundai Accent?

2009-2011 models use one OCV valve for the intake camshaft, while 2012 and later models use two. The sensor is located on the driver's side cylinder head for 2006-2011 models, and on the timing chain side for 2012 and later models. To remove, disconnect the negative battery terminal and the CVVT oil control valve connector, then remove the mounting bolt and valve. Installation is the reverse of removal, with the O-ring coated in clean engine oil.

Genuine Hyundai Accent Spool Valve

VTEC Solenoid

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

4 Spool Valves found

View related parts
Hyundai Accent Oil Control Valve Assembly
Part Number: 24355-2B700
$75.70 MSRP: $106.35
You Save: $30.65 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Control Valve Solenoid
- Warranty: This genuine part is guaranteed by Hyundai's factory warranty.
Fits the following Vehicles:
- 2011-2022 Hyundai Accent | DOHC - GDI | Sedan - 4Door 5P, Sedan - 5Door 5P
View related parts
Hyundai Accent Oil Control Valve Assembly
Part Number: 24355-26710
$258.83 MSRP: $363.65
You Save: $104.82 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Manufacturer Note: DENSO CORPORATION
- Replaces: 24355-26703-2, 24355-26703
- Warranty: This genuine part is guaranteed by Hyundai's factory warranty.
Fits the following Vehicles:
- 2005-2011 Hyundai Accent | High Grade, Middle Grade | DOHC - MPI | 3 Door Sedan, 4 Door Sedan, Sedan - 3Door 5P, Sedan - 4Door 5P
View related parts
Hyundai Accent Oil Control Valve Assembly
Part Number: 24355-26703
$258.83 MSRP: $363.65
You Save: $104.82 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Replaced by: 24355-26710
- Warranty: This genuine part is guaranteed by Hyundai's factory warranty.
Fits the following Vehicles:
- 2005-2011 Hyundai Accent | High Grade, Middle Grade | DOHC - MPI | 3 Door Sedan, 4 Door Sedan, Sedan - 3Door 5P, Sedan - 4Door 5P
View related parts
Hyundai Accent Oil Control Valve Assembly
Part Number: 24355-26800
$258.83 MSRP: $363.65
You Save: $104.82 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Manufacturer Note: DENSO KOREA AUTOMOTIVEDENSO KO
- Warranty: This genuine part is guaranteed by Hyundai's factory warranty.
Fits the following Vehicles:
- 2006-2011 Hyundai Accent | DOHC - MPI | Sedan - 3Door 5P, Sedan - 4Door 5P

Hyundai Accent Spool Valve

The Hyundai Accent Spool Valve is designed to help fine-tune cam timing in real time. This allows the engine to breathe efficiently for better pull and improved gas mileage. Working as an ECU-directed switch, this Spool Valve routes oil pressure to shift the cam position a few degrees. This small change can swing power output by dozens of horsepower if set incorrectly. Early generations of the Accent applied a simple single profile Spool Valve that advanced or retarded the intake cam. Later versions of the Accent applied an upgraded dual range Spool Valve that could trim timing over a wider rpm span for smoother idle and sharper high rev response. On current Hyundai Accent models, the same principle applies, but integration with smarter engine control software makes transitions almost seamless. Both styles use the same basic technique, which is routing pressurized lubricant through interior passages rather than a chain or gear revision. This allows adjustments to occur instantly without removing covers or sprockets. Hyundai also provides OE spec timing covers that keep debris away from the valve assembly. The Spool Valve is digitally responsive, allowing Hyundai drivers the benefit of factory calibrated precision as well as the liberty for the engine control unit to juggle power and efficiency on every drive.

If you are looking for affordable high-quality OEM Hyundai Accent Spool Valve, then you have come to the prime place. Our website provides a large amount of genuine Hyundai Accent Spool Valve at unbeatable prices. All our parts come backed with the manufacturer's warranty.

Hyundai Accent Spool Valve Parts Questions & Experts Answers

Oil Control Valve Assembly
24355-2B700
Q: What information can you provide about Spool Valve and sensor locations on Hyundai Accent?
A:
2009-2011 models use one OCV valve for the intake camshaft, while 2012 and later models use two. The sensor is located on the driver's side cylinder head for 2006-2011 models, and on the timing chain side for 2012 and later models. To remove, disconnect the negative battery terminal and the CVVT oil control valve connector, then remove the mounting bolt and valve. Installation is the reverse of removal, with the O-ring coated in clean engine oil.