Hyundai 49507-24A00 Joint & Shaft Kit-Front Axle W

To remove the wheel cover and loosen the axle shaft hub nut, raise the front of the vehicle and support it securely on jackstands. Remove the front wheel. Remove the axle shaft hub nut by bracing a screwdriver across two of the wheel studs. On 1994 and earlier models, remove the two balljoint-to-lower arm bolts/nuts and separate the lower arm from the balljoint. On 1995 and later models, detach the lower arm balljoint from the strut knuckle assembly, detach the steering tie-rod, and detach the stabilizer bar. Press the axle shaft from the hub with a puller, then pull out on the steering knuckle and remove the outer end of the axle shaft from the hub splines. Before removing the axle shaft from the transaxle, drain the transaxle fluid. Carefully insert a prybar between the transaxle case at the case rib and the Constant Velocity (CV) axle shaft joint and pry while supporting the CV joints. Do not insert the prybar too deep to prevent damage to the differential oil seal. Pry the old circlip from the inner end of the axle shaft and install a new one. Lubricate the differential seal with multi-purpose grease, raise the axle shaft into position while supporting the CV joints and insert the splined end of the inner CV joint into the differential side gear. Apply a light coat of multi-purpose grease to the outer CV joint splines, pull out on the strut steering knuckle assembly and install the stub axle in the hub. Connect the balljoint to the lower arm. Install the hub nut using a new large washer underneath it. Grasp the inner CV joint housing and pull out to make sure that the axle shaft has seated securely in the transaxle. Install the wheel and lower the vehicle. Tighten the hub nut to the specified torque and install the wheel cover.